Open the tab “Monitoring”.

The screen will open, displaying current values of the parameters set up by the indicated Method of calculations.

“Time of parameter measurement in the last message” (DD/MM/YYYY hh:mm:ss) — time of recording the value/event from the last message.

‘Last message received” (DD/MM/YYYY hh:mm:ss) — time the last message was received by the conversion server.

The following parameters can be displayed in the section “Monitoring” depending on the type of the third-party terminal:

• Flag Power supply status;
• Flag Additional power supply status;
• Flag CAN Engine speed;
• Flag Roaming;
• Flag Ignition;
• Flag GSM connection;
• Flag GPS accuracy;
• Flag Panic button;
• Flag Device tampering;
• Flag CAN data availability;
• Flag Discrete output status;
• Flag Movement;
• Latitude, deg;
• Longitude, deg;
• GPS speed, kph;
• GPS direction, deg;
• GPS height, m;
• Number of satellites;
• DOP/HDOP
• Main power, V;
• Additional power, V;
• Absolute mileage, m;
• Relative mileage, m;
• Speed, kph;
• Engine speed, rpm;
• Acceleration magnitude, 0.01 g;
• LLS<N> Temperature, °C;
• PCB board temperature, °C;
• X-wise acceleration, 0.01 g;
• Y-wise acceleration, 0.01 g;
• Z-wise acceleration, 0.01 g;
• Temperature sensor <N>, °C;
• Built-in battery voltage, V;
• CAN (SPN245) mileage;
• CAN (SPN1624) Instantaneous speed;
• CAN (SPN190) engine RPM;
• CAN (SPN168) voltage;
• Coordinates quality;
• CAN fuel level;
• LLS<N> Level;
• LLS<N> Status;
• GSM signal strength;
• Flag Moving;
• DOP/HDOP;
• Code i-Button;
• Analogue input <N>;
• Absolute counter <N>;
• Relative counter <N>;
• Discrete input <N>.
• SPN-96 Fuel level in tank No. 1;
• SPN-38 Fuel level in tank No. 2;
• SPN70 — parking brake status;
• SPN91 — accelerometer pedal position;
• SPN100 — engine oil pressure;
• SPN110 — coolant temperature;
• SPN174 — fuel temperature;
• SPN175 - engine oil temperature;
• SPN182 — daily fuel consumption;
• SPN184 — Instantaneous fuel economy;
• SPN244 — daily mileage;
• SPN247 — total engine operation time;
• SPN250 — total fuel consumption;
• SPN521 — service brake pedal position;
• SPN522 — clutch pedal position;
• SPN527 — cruise control status;
• SPN582 /*PGN 65258 */ — axle load;
• SPN597 — service brake pedal status;
• SPN598 — clutch pedal status;
• SPN914 — mileage until the next technical maintenance;
• SPN916 — Engine run time until the next technical maintenance;
• SPN928 /*PGN 65258 */ — axle index;
• SPN1821 — door status;
• SPN1856 — seatbelt status;

“Measured” — the last time the parameter value was recorded by the third-party terminal.

“Received” — the last time the parameter value was received by the conversion server.