In the section “Device tampering”:

In the field “Method of calculation”, select the parameter based on which Omnicomm Online software will record terminal tampering.

Possible values depending on the type of the terminal being connected:

• “Always closed device”. This Method of calculation is a default value or is set up if it is not required to control tampering sensor status. Omnicomm Online software will always display no tampering of the device.

• Flag “Device tampered”. This Method of calculation is set up if the third-party terminal transmits information about the tampering sensor status. Omnicomm Online software will record tampering of the device when receiving a respective event from the third-party terminal.

• From discrete input <N>. This Method of calculation is set up if the tampering sensor is connected to a discrete input of the third-party terminal. Omnicomm Online software will record tampering of the device when receiving the event of discrete input on from the third-party terminal.

If it is required to record tampering of the case of the device when receiving the event of discrete input off, tick the box “Invert”.