Installer actions:

1. Arrival at the site.
2. Cutting the sensor to match the tank length.
3. Prepare all necessary settings according to chapter 2 of this manual.
4. Installing the sensor into the tank.
5. Connecting the sensor to the GPS tracker.
6. Recording the tank type (cylindrical / parallelepiped).
7. Completing the installation without performing calibration.

Customer responsibilities:

• Perform a full tank refueling at a convenient time.
• Assign a responsible employee.
• Provide technical support with:
  • refueling volume (according to the receipt);
  • date and time;
  • location (fuel station).

When installing the sensor without calibration, one full-tank refueling is mandatory.

To improve calibration accuracy, an additional 2–3 refuelings are recommended (not necessarily full).

Responsibilities:

• Locate refueling data in the FMS;
• Determine sensor values before and after refueling;
• Enter data into the calibration service;
• Generate the calibration table;
• Upload the table to the FMS.