In the “Service” menu select “Restart Terminal”.

In the «Settings» tab select the «Auxiliary equipment»section from the list.

In the «Password settings» section:

If you need to use a password to configure the terminal settings, in the field “Ask for password when saving settings” select “Enabled”. Default value — disabled. Press the “Record into device” button. A window will open:

“New password” and “Confirm new password” – enter a new password that will be used to get access to settings configuration. The password shall contain 8 characters maximum.

Press the “Save” button. A window will open:

Press the “Save” button.

Press the “Record into device” button.

In the «Settings» tab select the «Connection» section from the list.

In the «Data collection and transmission blocking» section:

To block the terminal data collection and transmission in the “Lock” field select “Enabled”:

To unlock data collection and transmission use Omnicomm Configurator or send SMS command *UNBLOCK# to the SIM card, inserted in the terminal.

Set password on terminal settings modification by either of the following ways:

• When configuring the terminal using Omnicomm Configurator set password on settings modification that is different from the password set by default. Default password – 0000
• Send SMS command to change password set by default: *SETPWDID 212009988 12345#

where: 212009988 – terminal ID; 12345 – password to be set. The password shall contain 8 characters maximum and may include any digits and letters.

After 6 hours, the terminal will be authorized on the Remote Configuration Server and will be available for operation via the Remote Configuration Server.

The terminal SIM card telephone number is automatically displayed in the Remote Configuration Server after the second connection to the RCS.