Driving Safety Control
In the «Settings» tab select the «Auxiliary equipment» section from the list.
In the «Accelerometer parameters» section:
“Accelerometer” – enable/disable the use of accelerometer for measuring the vehicle acceleration. Default value — enabled.
“Accelerometer status” – accelerometer condition. Possible options: not used, calibration, calibrated, calibration error.
“Accelerometer calibration” – select the accelerometer calibration mode. Possible options: automatic calibration, manual calibration.
Prior to performing the calibration, firmly fix the terminal and do not change its position during operation.
Automatic calibration is recommended for vehicles that are operated mainly at speeds above 50 km/h. Automatic calibration takes between 2 minutes and 24 hours, depending on the frequency of acceleration and braking on straight sections of the road.
When selecting manual calibration, in the “Terminal position” field, select one of 24 positions as shown in figure:
Deflection of the terminal from the axes during manual calibration should not be more than 5 degrees.
In the «Settings» tab select the «Driving Control» section from the list.
«Dangerous driving control» – enable/disable registration of dangerous driving when exceeding the set values of monitored parameters.
Select monitored parameters:
«Sending an event» –enable/disable event sending to Omnicomm Online.
- «Speed» – vehicle speed control
Threshold – enter the maximum permissible speed, upon exceeding which dangerous driving will be registered. Possible values: 0 to 150 km/h. Default value: 80 km/h.
Deviation – enter the speed value that can be exceeded maximum permissible speed without triggering dangerous driving. Possible values: 0 to 50 km/h. Default value: 5 km/h.
Duration – enter the period of time allowed to exceed maximum permissible speed without triggering dangerous driving. Possible values: 0 to 300 s. Default value: 15 s.
- «Engine speed (RPM)» – engine RPM monitoring
Threshold – enter the maximum permissible engine RPM, upon exceeding which dangerous driving will be registered. Possible values: 0 to 10,000 rpm. Default value: 4,000 rpm.
Deviation – enter the RPM value that can be exceeded by maximum permissible RPM without registration of violation.Possible values: 0 to 1000 rpm. Default value: 200 rpm.
Duration – enter the period of time allowed to exceed maximum permissible engine RPM without registration of dangerous driving. Possible values: 0 to 300 s. Default value: 15 s.
- «Acceleration» – acceleration control during vehicle speeding up
Threshold – enter the value of acceleration while speeding up, which exceeding will trigger registration of dangerous driving
- «Lateral acceleration» – acceleration control during vehicle turning
Threshold – enter the value of acceleration while turning, which exceeding will trigger registration of dangerous driving
- «Braking» – acceleration control during vehicle braking
Threshold – enter the value of acceleration while braking, which exceeding will trigger registration of dangerous driving
- «Vertical acceleration (pounding / bumping)» – acceleration control during vehicle pounding
Threshold – enter the value of acceleration while pounding or bumping, which exceeding will trigger registration of dangerous driving
- “Send SMS for selected events” – enable SMS sending upon registration of dangerous driving
«Determine accidents» – enable / disable accident registration upon exceeding the set values of monitored parameters.
- «Speeding up threshold» – value of acceleration while speeding up, which exceeding will trigger registration of accident
- «Lateral acceleration threshold» – value of acceleration while turning, which exceeding will trigger registration of accident
- «Braking threshold» – value of acceleration while braking, which exceeding will trigger registration of accident
- «Send SMS upon triggering» – enable SMS sending upon registration of accident
