In the “Administration” section, open the “Repeaters” tab. Click the “Add” button. A window will open:

In the “Repeater Configuration” section:

“Repeater name” – enter the name of the repeater.

“Host” – specify the Host to which the retransmission will be conducted.

“Port” – specify the port to which the broadcast will be conducted.

“Protocol” – select the protocol by which the retransmission will be conducted.

“Comment” – enter a comment to the repeater.

“Login / Password” – Enter the login and password for the services that require authentication.

“Add a prefix as a leading value of up to 9 characters in the identifier” – specify a number if you need to add a leading value to the terminal identifier when sending to the recipient.

“Timeout, sec” IDs of terminals, specify the timeout value. Possible values: from 1 to 999.

“Interval between repetitions, sec” – specify the value of the interval between repetitions in case of unsuccessful data transfer. Possible values: from 1 to 999.

In the “Terminals” section:

Click the “Add” button and choose the method of adding:

• Through the vehicle tree – A list of vehicles will appear; select the vehicles whose terminals need to be added to the retransmitter.

• Through entering the ID – A window will open where you can enter the IDs of the required terminals.

“Start retransmission from” – Select the date and time when the retransmission should begin. For transmitting archive data, specify a date earlier than the current one.

“To” – Select the date and time until which retransmission should be performed. Leave this field empty to continue retransmission until manually stopped.

Click the “Restart” button to start retransmitting the selected terminals from the specified date.