Set up configuration parameters as described below:

On the “Settings” tab, in the “Configurable parameters” section:

Filtering – set the output signal filtering parameters:

• None – no filtering is applied. Used when filtering is performed by an external device.
• Minimum – filtering is used when the device is installed in stationary fuel storage tanks and low-mobility equipment.
• Medium – filtering is used when the vehicle operates under normal road conditions.
• Maximum – filtering is used when the vehicle operates under harsh road conditions.

Signal type – select Analog or Frequency.

For an analog signal:

• Max. voltage value (5 … 20) V – set the maximum voltage value. The default value is 5 V.
• Min. voltage value (0 … 15) V – set the minimum voltage value. The default value is 0 V.

For a frequency signal:

• Max. frequency value (100 to 2000) Hz – set the maximum frequency value. The default value is 2000 Hz.
• Min. frequency value (30 to 1900) Hz – set the minimum frequency value. The default value is 30 Hz.

• Pull-up – if, according to the manufacturer’s description, a voltage signal is connected to the input of the external device, select On. If a “dry contact” signal or an NPN transistor switch is connected, select Off.