In the section “Speed according to the sensor”:

In the field “Method of calculation”, select the parameter based on which Omnicomm Online software will calculate the VH speed.

Possible values depending on the type of the terminal being connected:

• Speed sensor. This Method of calculation is set up if the third-party terminal transmits the speed values from VH speed sensor readings;

• Analogue input <N>. This Method of calculation is set up if the speed sensor is connected to an analogue input of the third-party terminal. Omnicomm Online software will record the speed value when receiving a respective value from the third-party terminal;

• CAN parameter: SPN1624. This Method of calculation is set up if the third-party terminal transmits mileage values from the bus CAN signal SPN1624;

• From CAN parameter «N». This Method of calculation is set up if the third-party terminal transmits the speed value from the bus CAN, and the signal is different to SPN1624. Select CAN signal value by which Omnicomm Online software will record the speed value;

“Conversion factor to kph” — enter the factor by which to multiply the received speed value to convert it to kph.