In the section “Roaming”:

In the field “Method of calculation”, select the parameter based on which Omnicomm Online software will record when the VH is roaming.

Possible values depending on the type of terminal being connected:

• “Always in a home network”. This Method of calculation is a default value or is set up if it is not required to control the presence in roaming. Omnicomm Online software will display the permanent presence of the terminal in the home network.

• Flag “Roaming”. This Method of calculation is set up if the third-party terminal transmits information about the presence in roaming. Omnicomm Online software will record the presence in roaming when it receives the event of presence in roaming from the terminal.