Omnicomm Online allows sending messages to the Omnicomm Connect mobile app.

To set this up:

1. In the Omnicomm Online interface, go to the “Administration” section.
2. Open the “Vehicles” tab.
3. Click “Add Mobile App”. A new window will appear:

Vehicle Name – Enter the name of the vehicle. Active – Check this box to enable the mobile app.

Click “Save”. A window will appear.

Save the login and password to access the mobile app.

Configure the Mobile App Profile

In Omnicomm Online, go to the Administration section.

Open the Vehicles tab.

Select a vehicle with a mobile app and click “Vehicle Profile”. A new window will open.

Virtual Vehicle Section:

Login – The login for accessing the mobile app.

Password – To change the password, click Replace.

Active – Check this box to enable the mobile app.

Data Collection Interval, sec – Set the polling interval for the app.

Phone – Enter the SIM card number associated with the app.

Vehicle Section:

Vehicle Name – The license plate or unique name of the vehicle (e.g., 10 RU A 123BV). The name must be unique in Omnicomm Online and cannot exceed 100 characters.

Purpose – Specify the vehicle's purpose within the organization.

Brand – Enter the vehicle's brand.

Groups – Click Select Group and choose the relevant group(s) for the vehicle.

Vehicle Category – Select a category:

• Categories A, B, C, D, E, F (per Russian traffic regulations)
• Category SPEC (special equipment)

Movement Section

Mileage and Speed Calculation Method: Choose the method:

• “By terminal data (excluding coordinate outliers)” – Calculates mileage using terminal data while filtering drift coordinates.
• “By terminal data (without excluding coordinate outliers)” – Calculates mileage directly from terminal data.

Speed Sensor Correction Factor

Maximum Allowed Speed, km/h

Monitor Stops Longer Than (min): Check the box and set the duration to log stops.

Monitor Parking Longer Than (min): Check the box and set the duration to log parking.

Consider Ignition for Stop/Parking Detection: Enable this option if ignition state should be considered.

Conditions for logging stops/parking:

With ignition consideration: Logged when the ignition is off and the time exceeds the specified duration.

Without ignition consideration: Logged when the speed is less than 2 km/h, and consecutive events meet:

Distance between events is less than 800 m.

Total duration exceeds the specified time.

Statuses Section

Default Statuses: Use pre-configured statuses.

Custom Statuses: Create personalized statuses.

To add custom statuses:

Name – Enter the status name to display in Omnicomm Online.

• Color – Select a color for the status.
• Use the Add Status link to create as many statuses as needed.

Configure the parameters as required to optimize the system for your organization's needs.